e-mail:

phone:

based in:

ian@pegdecking.com

07710 767614

Denton, Northants

Garden decking from around Northamptonshire, including Billing, Bozeat, Brafield, Cogenhoe, Crick, Denton, Duston and Earls Barton
Garden decking from around Northamptonshire, including Grange Park, Great Doddington, Grendon, Harlsetone, Hartwell, Higham Ferrers and Lavendon
Garden decking from around Northamptonshire, including Mawsley Village, Moulton, Newport Pagnell, Olney, Overstone, Roade, Rushden, Towcester, Turvey, Upton, Wellingborough, West Haddon, Wollaston, Wootton

Timber Decking Display for HFS Timber - Harlestone

This is the display I built for HFS Timber (Harlestone Firs Sawmill) so if you want to see some decking “in the flesh” then please pay them a visit. It is a bit of a “mishmash” but it was designed to show people what is possible and to give some ideas.

Deck Features (click to see others with this feature):

 

This is the finished deck, which you may have seen before. The brief was to build a large deck, with as many features as possible, to give people ideas as to what could be done and to display as many different products as possible. On this deck you will see that there are both round and square Newel posts and spindles. The actual decking has been laid in many different directions as well as “upside down”. It is raised, split level and incorporates various steps and a hatch for access to a septic tank.

There are many pictures of the deck, some of which you can see on the HFS web site (www.hfstimber.co.uk) and elsewhere, so I will try and pick some that you may not have seen before.

 

 

This shows part of the frame and the start of some of the decking. The posts on the right form an integral part of the frame supports but are also extended to take fence panels. In the centre of the picture, laid on the frame, you can see a support post which has been notched out ready for fitting and bolting through.

 

 

This shows how the frame and supports are jointed. Notice how the bearers are fitted into the notched support and then bolted through.

 

 

This picture was taken from the corner before someone decided to cover this part with a “summerhouse”. Note how the decking is laid in different directions on each level. There is no special reason for this other than to show that it can be done for aesthetic effect. The deck has a slight fall from front to back so it will drain equally well with the planks in either direction.

 

 

Here you can see an area where the deck planking is laid “smooth side up”. It is arguably easier to clean, but personally, I think it would be too slippery when wet. You can also see the hatch cover over the septic tank, which rather than hide, we made into a sort of feature.

 

 

In case you haven’t seen it before, this was the site when work commenced. Note that the ground is “rock hard” because it has had timber stacked on it and vehicles driven over it for generations, and would be very difficult to dig. For this reason, these posts are not set in the ground at all. However, because they would have to support fence panels, a “double frame” was built to support the posts, both at deck height and at ground level.

« Back to previous page